Most of the difference between a lumpy upholstery job and a clean one comes down to setup and tension. The tips below are habits that working upholsterers rely on. They are simple to learn, and they make the finished piece look much more deliberate. For the full sequence, see the complete guide to reupholstering furniture.
Mark your centers before you staple
Before you pull any fabric, mark the center of each side of the frame rails. Use chalk or small notches on the frame. Mark the matching centers on the fabric edges too. When the marks line up, the fabric starts out square, and the rest of the job is easier to keep even.
Set the fabric with temporary staples
Drive a few staples partway in to hold the fabric in place. Check that the grain is straight and the pattern sits where you want it. Adjust the fabric, then drive the staples fully. Temporary staples let you correct a mistake before it is locked in.
Staple in a set order
Start with the center of each side. Then work outward toward the corners, alternating directions so the tension stays even. This order matters more than the number of staples.
Staple close to, but not on, the edge of the rail. Stagger the rows so the wood does not split. Too many staples in one line weakens the rail, and extra staples do not fix poor tension.
Keep the grain straight
Keep the horizontal threads parallel to the floor and the vertical threads plumb. A fabric that looks straight on the bolt can lean once it is stretched, so check it again after each side.
Pull the fabric snug, but do not over-stretch it. Over-tight fabric distorts the weave and pulls the pattern off line. Tighter is not always better.
How to upholster inside corners
Corners are where most of the bulk builds up. A clean method looks like this:
- Fold the excess into one or two neat pleats. Keep the pleats flat against the frame.
- Trim the inner bulk before stapling. Cut away thick layers so the corner lies flat.
- Make relief cuts short. When fabric wraps around a leg or arm post, cut a small Y or V shape. Start short and extend the cut only as far as you need.
Practice on a slip seat or footstool before you try a sofa corner. The beginner projects guide lists good first pieces.
Foam and batting for a smooth finish
Cut cushion foam about half an inch larger than the finished cover. This gives a fuller, rounded cushion. Wrap the foam in polyester batting so the edges look smooth and the fabric does not rub directly on the foam.
To get a foam cushion into a tight cover, wrap it in a thin plastic bag, slide it in, and pull the bag out. The bag lets the foam slide without catching.
Hide staples at show wood
Where fabric meets exposed wood, you can cover the staples with double welt or gimp. Attach the trim with hot glue or fabric glue. Using glue for trim is standard practice, not a shortcut.
Patterns, nap and motifs
Center large motifs on the seat, the inside back and each cushion. Match patterns across cushions so they line up when the piece is put together. Velvet has a nap that catches light differently depending on direction. Keep the nap consistent across the piece. Conventions vary, but running the nap down on backs and toward the front on seats is a common choice.
Steam with care
Steam can relax wrinkles and help fabric curve around a shape. Test a small hidden spot first, because some fabrics leave water spots.
Frequently asked questions
Can you do upholstery yourself? Yes, for simple pieces such as slip seats and footstools. Larger pieces need more fabric, more practice and more tools. The complete guide explains what to expect.
What are some easy upholstery projects for beginners? A drop-in dining seat is the usual first project. The beginner projects guide lists others in order of difficulty.
What are some uses for upholstery fabric? Upholstery fabric is heavy and durable, so it suits furniture covers, cushions and bags. Swatches can also be sewn into pouches, totes and small baskets. The beginner projects guide covers these ideas.
Safety
Wear eye protection when you staple and strip. Staples can fly when they release, and the points are sharp.