DIY Reupholstery

How to Take Apart a Chair for Reupholstering

How to take apart a chair for reupholstering: photograph and label every piece, remove the outside parts first, and inspect the frame and springs as you go.

On this page
  1. Photograph before you start
  2. Tools and workspace
  3. The order of removal
  4. Loose cushions, legs and hardware
  5. Label and keep the pattern pieces
  6. Open ply-grip and tack strips carefully
  7. Inspect the frame
  8. Inspect the suspension
  9. Decide what to keep
  10. Safety
  11. Frequently asked questions

To take apart a chair for reupholstering, photograph and label every piece before you unscrew anything. Then remove the outside pieces first, working inward toward the seat. Keep each piece whole, because the old fabric is your pattern. Inspect the frame and springs as they are exposed, since you will not get another look at them once the new padding is on.

Photograph before you start

Take photos from all sides before you begin, and again at each stage. Focus on:

  • Where the welt sits
  • Where the pleats fold
  • Where the fabric pulls through to the underside
  • Where the staples and tack strips run

Photos are cheap insurance. Pleats and pull-through points are hard to remember once the chair is in pieces.

Tools and workspace

  • A sawhorse or padded table at a comfortable working height
  • A screwdriver, a staple remover and pliers
  • Gloves
  • Labeled bags or containers for screws, bolts and leg plates
  • A marker for labeling fabric pieces

The order of removal

Remove the pieces in the reverse of the order they were built. For a typical padded chair or sofa, the order runs like this:

  1. Dust cover
  2. Outside back
  3. Outside arms
  4. Arm fronts
  5. Inside back
  6. Inside arms
  7. Seat or deck
  8. Padding

The common mistake is starting with the seat. Outside pieces come off first.

Loose cushions, legs and hardware

Remove any loose cushions first. Then unscrew the legs or casters if they come off. Bag and label every screw, bolt and leg plate as you go, so you can match them up later. A labeled bag is much easier than a pile of mixed hardware.

Label and keep the pattern pieces

Write the name and orientation on each piece as you remove it, such as “inside back, top” or “arm front, left.” Keep each piece whole. Old fabric is not trash. It is the best pattern you will get for the new cover.

Open ply-grip and tack strips carefully

Metal ply-grip or curve-ease strips hold fabric along the edges. Pry them open gently with a flat tool, and avoid bending them out of shape. Note where any cardboard tack strips sit, because you will need to replace them.

Inspect the frame

With the cover off, check the frame and joinery:

  • Re-glue and clamp any loose joints.
  • Replace cracked corner blocks.
  • Repair split rails.

Make these repairs before the padding goes back on. A joint is much easier to fix while the frame is exposed.

Inspect the suspension

Check the springs and webbing for:

Fix these before the new padding goes on. Once the foam and fabric are in place, these faults are hidden and hard to reach.

Decide what to keep

Replace foam that crumbles, has yellowed and powdered, or stays compressed. Good cotton or horsehair can often be reused. Do not reuse old padding by default. Check its condition first, because worn padding often leaves lumps under the new cover.

Safety

  • Wear eye protection when you remove staples and tacks.
  • Wear a dust mask. Old padding sheds dust, fibers and mold spores.
  • Wear gloves when you handle old springs and tack-filled rails.

Frequently asked questions

How long does it take? Roughly 2 to 6 hours to strip an armchair, depending on its size and how many staples it has.

Should I take the whole chair apart? Take apart the parts you are re-covering, inspecting or replacing. Leave the rest in place if it is sound. For staple removal, see the staple removal guide. For the full project, see the complete guide to reupholstering furniture.

The complete guide to diy reupholstery

How to Reupholster Furniture: A Complete DIY Guide
Read the guide

Keep exploring

Guides from other topics

All topics →