To measure a sofa for upholstery, remove the cushions and measure each panel separately, at its widest and longest points. Add allowances for pulling, seams and tuck-in. Then lay the pieces out on a 54-inch-wide plan to estimate how much fabric you need.
Before you measure
- Remove the loose cushions. Measure them separately.
- Strip the old cover if you can. Measuring the actual old pieces is the most accurate method.
- Check for a nap or one-way print. A directional fabric changes how pieces are cut.
- Use a soft tape measure. A flexible tape follows the curve of the padding better than a rigid rule.
Measure each panel
Measure each of these panels:
- Inside back
- Outside back
- Inside arms
- Outside arms
- Arm fronts
- Deck
- Cushions (length, width and thickness)
- Skirt
Measure at the widest and longest points, following the curve of the padding. For tufted backs, press the tape into the button indentations and follow the contours. Arms usually come in pairs, so measure one and note that you need two.
Add the allowances
Most of the fabric you lose comes from allowances, so do not skip them.
- Pulling and stapling: about 2 to 4 inches of extra fabric per stapled edge.
- Seam allowance: about 1/2 inch per sewn edge.
- Tuck-in: about 4 to 6 inches where the inside back and inside arms meet the deck.
- Cushion boxing strip: the perimeter of the cushion plus seam allowance, plus overlap for any zipper.
Welt and piping
Total the linear length of all the welt you need. As a very rough guide, one yard of 54-inch fabric yields about 25 to 35 yards of 1.5-inch strips. That figure is approximate, so check it against your own layout.
Lay out the pieces and convert to yards
- Sketch each piece on a scaled plan with a width of 54 inches.
- Round each cut length up to a whole number of pattern repeats.
- Use railroading where it helps. Railroading runs the fabric’s length across the width of the piece. It lets a sofa back wider than 54 inches be cut without a seam.
- Add 10 to 15 percent for waste and mistakes.
Rough yardage
These are plain-fabric yardage estimates on 54-inch cloth:
| Piece | Yardage (plain fabric) |
|---|---|
| 3-seat sofa | 14 to 18 yd |
| Loveseat | 10 to 12 yd |
Large pattern repeats or a skirt add several yards. Treat these figures as a starting point, and check them against your own layout before ordering.
Common measuring mistakes
- Using overall dimensions. Overall length, depth and height are not enough to work out yardage. Each panel needs its own measurement.
- Forgetting tuck-in and pulling allowance. This is the most common reason people run short.
- Ignoring the pattern repeat. This matters even on small prints. If you ignore it, the cushions will not match.
- Buying fabric in separate batches. Dye lots can differ, so buy everything in one order.
Frequently asked questions
Do I need to measure the cushions separately? Yes. Cushions need their own measurements for length, width and thickness, plus a boxing strip for the sides.
How much extra fabric should I buy? Add the allowances above first. Then add about 10 to 15 percent for waste. If the fabric has a large pattern, add more.
For the cost side of a sofa project, see the cost guide. For the full process, see the complete guide to reupholstering furniture.