Cost and Yardage

How do I calculate how much fabric I need for a project?

Measure each panel, add allowances for stapling and seams, lay the pieces on the fabric roll, then divide the length in inches by 36 to get yards.

On this page
  1. Measure each panel
  2. Add allowances
  3. Lay out and convert to yards
  4. Pattern repeats
  5. Other factors
  6. Common mistakes

To estimate fabric for a furniture project, measure each panel separately, add allowances for stapling and seams, and lay the pieces out along a strip of fabric the width of the roll. Divide the total length in inches by 36 to get yards. Round up, then add about 10 percent for waste.

Measure each panel

Measure each part at its widest and longest point. For most furniture, the list includes:

  • Inside back and outside back
  • Inside arms and outside arms
  • Seat deck
  • Front rail
  • Cushions

Don’t rely on the overall size of the piece. Two sofas of the same width can use very different amounts of fabric.

Add allowances

  • Stapled panels: add 2 to 4 inches to each dimension so there is enough to pull and handle.
  • Sewn seams: add about 1/2 inch per edge.
  • Boxed cushions: a boxed cushion needs a top, a bottom and a boxing strip. The boxing strip should be as long as the cushion’s perimeter and as wide as the cushion’s thickness plus 1 inch.

Make a paper or muslin template for odd shapes such as arm fronts and wings. It’s easier to check a shape than to guess it.

Lay out and convert to yards

Lay the panel sizes out along a strip of fabric as wide as the roll, usually 54 inches for upholstery. Add up the length the layout uses, then divide by 36.

Here is a worked example. Suppose the layout needs 150 inches of fabric length:

  1. 150 ÷ 36 = 4.17 yards
  2. Add about 10 percent for waste: 4.17 × 1.1 ≈ 4.6 yards
  3. Round up to the next practical amount: buy 5 yards

Narrower fabric needs more yardage, because fewer panels fit across the roll. Check the width before you calculate.

Pattern repeats

Round each cut length up to the next full pattern repeat, so the design lines up at the seams. A general rule is to add 10 to 25 percent for patterned fabric. Large repeats can need more. One upholstery shop’s published guide adds 10 percent for repeats of 3 to 14 inches, and rises in steps to 35 percent for repeats of 44 to 51 inches.

Other factors

  • Railroading: turning the fabric 90 degrees can avoid seams on wide pieces such as sofa backs. Recalculate the layout if you do it.
  • Nap and pile: velvet and chenille have a direction. All panels must run the same way, which can add yardage.

Common mistakes

  • Leaving out the pull allowance. Panels cut to exact size are too short to staple.
  • Measuring the overall size instead of each panel. This gives an answer that’s often wrong.
  • Ignoring fabric width. Fabric widths vary, and quilting or apparel widths of 42 to 45 inches don’t match upholstery charts.
  • Buying in pieces. Dye lots can differ, so buy the full amount at once.

For quick numbers by piece, see the upholstery yardage chart. For pricing, see the upholstery cost pricing chart.

The complete guide to cost and yardage

Upholstery Cost: Pricing Chart for Reupholstering Furniture
Read the guide

Keep exploring

Guides from other topics

All topics →