Leather

Leather Upholstery Guide: Types and Tips

A practical leather upholstery guide: grades, finishes, how to tell them apart, care, repairs, recolouring and reupholstering in leather furniture.

On this page
  1. What leather upholstery is
  2. Leather grades
  3. Finish types: aniline, semi-aniline and pigmented
  4. Caring for leather furniture
  5. Fixing common problems
  6. Recolouring, dyeing and restoring
  7. Reupholstering in leather
  8. What not to use on a leather couch
  9. Common misconceptions
  10. A simple plan

What leather upholstery is

Leather upholstery is hide that has been tanned and finished for use on furniture. Most upholstery leather is chrome-tanned, which keeps it soft and colourfast. Vegetable-tanned leather is stiffer and is rarely used on sofas.

The word “leather” covers a wide range of products. Two sofas can both be described as leather and still behave very differently when you clean, repair or wear them. Two things decide most of that: the grade of the hide and the finish on the surface.

Leather grades

The grade describes how much of the hide’s surface is left:

  • Full-grain. The top layer of the hide, left unsanded, with its natural marks. It is the most durable and develops a patina over time. It is usually the most expensive.
  • Top-grain. The surface has been sanded or corrected, and is often embossed to a more even grain. It is durable and common on furniture, but it is a grade below full-grain, not the top grade.
  • Split. Made from a lower layer of the hide. It is usually coated to look like grain and is less durable.
  • Genuine leather. A marketing term rather than a quality grade. It often describes split leather. Don’t read it as “best”.
  • Bonded leather. Shredded leather fibres glued to a backing with a polyurethane surface. It is a composite, and it usually peels within a few years.
  • Faux leather (PU or vinyl). A synthetic material. It cleans easily but doesn’t age like hide.

Many sofas use a leather match: real leather on the seating surfaces, with vinyl or PU on the sides and back. Check the back and sides before you assume the whole piece is leather. For a set of checks, see how to tell if a couch is real leather.

A good top-grain or full-grain sofa can last 15 to 25 years or more with care. Bonded leather often lasts only two to five years. Both figures vary a lot.

Finish types: aniline, semi-aniline and pigmented

The finish sits on the grain side of the leather. It matters more than the grade for daily care and repair.

  • Aniline. Dyed through, with no pigment coat. It is the softest and most natural-looking. It absorbs spills, fades in sunlight and shows marks easily.
  • Semi-aniline. Dye with a light pigmented coat. It has a more natural feel than fully pigmented leather, with some protection.
  • Pigmented (protected). Has an opaque polymer topcoat. It is the most durable and stain-resistant, and most leather furniture sold is pigmented.

Nubuck (a buffed surface) and suede (split leather with a napped surface) both stain easily and need their own care. They are not covered by the same routine as finished leather.

To tell which finish you have, put a drop of water on a hidden spot, such as under a cushion or on the back. If the water darkens and soaks in, the leather is absorbent, and it is aniline, semi-aniline or unfinished. If it beads on the surface, the leather is pigmented. The test doesn’t tell you whether the leather is real, because faux leather also beads.

For how the finish changes routine care, see leather furniture care.

Caring for leather furniture

Most leather care is simple and regular:

  • Dust and vacuum the seams weekly.
  • Blot spills right away with a dry cloth. Don’t rub.
  • Keep the sofa out of direct sun and at least about 60 cm (2 ft) from heat.
  • Clean with a leather cleaner suited to the finish, and test first.
  • Condition or protect every six to twelve months. Pigmented leather needs cleaning more than conditioning; aniline needs more care.

The care article sets out the full routine, including nubuck and suede.

Fixing common problems

The right fix depends on the damage:

  • Scratches. Depth decides the method. Surface marks need colour; deep gouges need filler; cuts need backing. See how to fix scratches on a leather couch.
  • Cracks. Fine cracks need a binder and colour. Deep cracks need flexible filler. Splits need a sub-patch first. See how to repair cracked leather furniture.
  • Fading and dull patches. On pigmented leather, a colour-matched balm may be enough. On aniline, the lost dye has to be replaced. See how to restore faded leather furniture.
  • Peeling in sheets. This usually means bonded leather. It can’t be repaired durably, so reupholstery or a new cover is usually the answer.

Recolouring, dyeing and restoring

These three jobs overlap but are not the same:

  • Restoring means bringing back worn or faded areas, usually with a balm or colourant and a seal.
  • Recolouring means changing the colour of a whole panel. On pigmented leather, this is a water-based colourant, not penetrating dye.
  • Dyeing usually refers to penetrating dye, which only works on aniline or unfinished leather.

Most furniture leather is pigmented, so the practical answer is usually a colourant. For a step-by-step, see how to dye or recolour leather furniture yourself.

Reupholstering in leather

Reupholster leather when the frame, foam or seams have failed, or when the leather itself is too worn or peeling to restore. Leather chairs and sofas can be reupholstered, but it is a skilled job, and new leather costs much more than fabric.

If you do the work yourself, a few basics matter:

  • Use a wedge-point leather needle (roughly size 100/16 to 110/18) and a bonded nylon thread (roughly Tex 70 to 90).
  • Use a walking-foot machine. Stitch length around 3.5 to 4 mm is a common starting point.
  • Hold pieces with clips, not pins. Pins leave permanent holes. Mark on the back of the leather.
  • Cut with a sharp blade on a cutting mat, away from your hand.
  • Leather sofas have more seams than fabric ones, because a single hide limits the size of each panel.

Recolouring is usually a fraction of the cost of reupholstering. Reupholstering in new leather often costs several times as much as recolouring, and a sofa can cost $2,000 or more. For the costs of recolouring, see how much does it cost to recolor a leather couch?

What not to use on a leather couch

Many household products damage leather finishes. Avoid these:

  • Dish soap and fairy liquid. They are not made for leather and can strip oils and finish. Some makers allow a very mild, diluted soap, so check first.
  • All-purpose sprays, glass cleaners, vinegar, ammonia and bleach. They strip the finish and dry the leather.
  • Alcohol-based cleaners and baby wipes. Alcohol and detergents dissolve the finish. See can I use baby wipes on a leather couch?
  • WD-40 and furniture polish. They leave a greasy film and can darken leather. See does WD-40 protect leather?
  • Olive, coconut or mink oil. They darken leather, can go rancid and attract dirt.
  • Saddle soap. It is made for vegetable-tanned tack, not finished upholstery.
  • Shoe polish. It rubs off onto clothing.

Common misconceptions

  • “Genuine leather” means high quality. It is often a lower grade.
  • Bonded leather is real leather. It is a composite of fibres and binder.
  • Top-grain is the best grade. Full-grain sits above it.
  • Pigmented leather needs frequent oiling. Its topcoat limits penetration. It needs cleaning more than conditioning.
  • Water beading proves a leather is fake. Pigmented leather beads too.

A simple plan

Put these habits in place and most leather upholstery stays in good shape:

  1. Weekly: dust and vacuum the seams.
  2. As needed: blot spills immediately and treat oil marks.
  3. Every one to three months: a gentle clean with a suitable cleaner, more often with heavy use.
  4. Every six to twelve months: condition or protect the surface.
  5. Each year: check for cracking, fading, and sticky or hazy patches. Call a professional for anything beyond surface care.

For each specific problem, use the related guide:

Keep exploring

Guides from other topics

All topics →