To decoupage fabric onto furniture, use a thin, tightly woven cotton, stick it down with a decoupage medium such as Mod Podge, smooth it flat, and seal it with two or three thin topcoats. Decoupage suits small, flat surfaces and light fabrics. It is not a substitute for upholstery on a seat.
What you need
- Fabric: thin, tightly woven cotton, such as quilting cotton or thin sheeting. Heavy, textured or stretchy fabrics do not lie flat.
- Medium: Mod Podge (matte, gloss or satin, or the fabric formula) or diluted PVA glue.
- Base: sandpaper, primer or paint, and a clean cloth.
- Tools: a brush, a brayer or a plastic card, an iron, scissors, and a sharp craft knife.
Prepare the furniture
Clean the surface, then lightly sand it with fine sandpaper, about 220 grit. Remove the dust. If the wood is dark or bold in colour, paint a light base coat or prime it with a white primer first. Thin fabric shows the colour underneath, so a dark wood will darken the fabric.
Prepare the fabric
Pre-wash cotton to remove sizing, then iron it flat. Skip fabric softener and dryer sheets, because they can stop the glue from bonding. Cut the fabric about 1 in (2.5 cm) larger than the surface on each side, so you have room to trim later.
Apply the medium and the fabric
Brush a thin, even coat of medium onto the surface, not onto the fabric alone. Work in sections so the medium does not dry before you place the fabric.
Lay the fabric on the wet medium. Smooth it from the centre outward with a brayer or a plastic card, pressing out air bubbles and wrinkles. A thick coat of medium causes wrinkles, bubbles and cloudiness, so keep the layer thin.
Trim the edges
Let the fabric dry for about 15 to 20 minutes. Pull the overhang slightly taut, then trim the excess along the edges with a sharp craft knife. Change the blade often, because a dull blade drags the fabric.
Seal the surface
Brush on two or three thin topcoats of medium or a clear sealer. Let each coat dry for about 15 to 20 minutes before the next. If you want a smoother finish, lightly sand between coats with very fine sandpaper. This step is optional.
The surface can take up to about four weeks to fully cure, so avoid heavy use for the first few days. Times vary by product, so check the label.
Tabletops and high-wear surfaces
For a tabletop, or any surface that gets daily knocks and spills, seal the decoupaged fabric with a water-based polyurethane. Ventilate the room while you apply it.
Common mistakes
- Treating Mod Podge as waterproof. It is water-resistant at most. Wipe spills up quickly.
- Applying thick coats. They cause wrinkles, bubbles and cloudiness.
- Using any fabric. Upholstery-weight fabric resists bonding and will not lie flat.
- Leaving the medium unsealed. An unsealed surface can turn tacky in heat and humidity.
Removing the fabric later
Decoupaged fabric can usually be removed with warm water and careful scraping. Work slowly, so you do not damage the wood or the base paint.
Safety
Use a fresh craft blade and cut away from your hand when you trim. Ventilate the room when you use polyurethane topcoats.
Related projects
For a no-sew cover on a larger piece, such as a headboard or a footstool, see DIY fabric-covered furniture. For a stronger adhesive on wood, see gluing upholstery fabric to wood.